Programming Odometer

Odometer setting can be programmed between 0 and 999999 km. It is only possible to program this parameter ONCE and then only if the reading is below 500 km. YES is displayed in the upper field if the mileage can be programmed. If programming is not permitted, NO is displayed. This means that either the mileage has been programmed before or that the mileage has exceeded 500 km. The actual stored mileage is displayed in the lower of the upper fields.

To program the mileage, enter the required value (in km) using the keyboard and press ENTER. Two buttons will be displayed. Select CONTINUE if the km value is correct. Then select LAUNCH PROGRAMMING. After programming is complete, NO is displayed in the uppermost field. The mileage programmed is displayed in the field underneath. Service interval reminder must be reset at same time as odometer. See RESETTING MAINTENANCE REMINDER  .