Gearshift Position Sensor, Side Cover, And Control System Solenoids - Removal And Installation
- Transmission
- Gear-shift position sensor, replacing (AW50/51 AWD; AW55-50/51SN)
- Preparations
- Remove the air cleaner (ACL) housing
- Remove the transmission cable from the bracket and the lever from the transmission
- Remove the gear-shift position sensor
- Remove the connector from the transmission
- Separate the connector on the transmission
- Detach the socket for the gear-shift position sensor
- Assemble the connector
- Connect the connector to the transmission
- Install the gear-shift position sensor
- Adjust the gear-shift position sensor
- Continued gear-shift position sensor installation
- Install the transmission cable on the transmission
- Install the air cleaner (ACL) housing
- Checking diagnostic trouble codes (DTCs)
- Gear-shift position sensor, replacing (AW55-50 1999)
- Notes
- Replacing the gear-shift position sensor
- Removing engine compartment components
- Removing the gearbox cable
- Removing the gear-shift position sensor
- Removing the connector from the gearbox
- Disassembling the connector on the gearbox
- Assembling the connector
- Installing the connector on the gearbox
- Installing the gear-shift position sensor
- Adjusting the gear-shift position sensor
- Installing the gear-shift position sensor, continued
- Installing the gear selector cable
- Installing engine compartment components
- Checking the diagnostic trouble codes (DTCs)
- Replacing the three-way catalytic converter (TWC)
- Side cover transmission, replacing
- Solenoids, control system, replacing
- Notes
- Solenoids, control system, replacing (AW50-42 1999)
- Notes
- Removal
- Preparations
- Remove the terminal from the transmission
- Install the lifting beam and lifting hook
- Raise the car
- Removing the right-hand drive shaft
- Remove the screws for the cable conduit and the ground lead bracket on the sub-frame
- Remove the ball joint nuts (both sides)
- Remove the bracket for the power supply cable to the heated oxygen sensor (HO2S) from the sub-frame
- Disconnect the steering gear from the sub-frame
- Remove the screws for the sub-frame support brakes, both sides
- Lower the sub-frame
- Drain the transmission oil
- Remove the control system cover
- Checking the solenoids
- Information, versions and combinations
- Reinstall the control system
- Assembling the control system
- Solenoids, control system, replacing (AW55-50 -2000)
- Splines, greasing
- Gear-shift position sensor, replacing (AW50/51 AWD; AW55-50/51SN)