Checking cable

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition on
• Try to activate the motor.

HINT: The resistance between #1E and #2E must be approximately 0 Ω. 

Check the cable between the power seat module (PSM) #2E and the motor. Check for an open-circuit. See Open-circuit, permanent faults .

Remedy as necessary.

If no fault is found, try replacing the motor.

Other information: 

• To access or replace the motor, see Front-rear adjustment motor (-2004) or Electric motor cushion, replacing (2005-)
• To connect the breakout box, see Connecting the breakout box, power seat module (PSM)
• For information about signals, see Connector, black (12-pin) .

Fig 2: Identifying Breakout Box

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Audio Control Module (AUM) / External Amplifier To Loudspeakers And Gray Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification