Connecting the Breakout Box
Special tools:
Connecting the Breakout Box
- Ignition off.
- Remove the door panel
- Disconnect the module connectors.NOTE: Unplug the 12-pin connector before the 30-pin connector.
Connect the adapter to the control module's connector. Connect breakout box 9511428 and cable harness 9511499 to the adapter.
Adapter cable harness 9511507 is for the 12-pin connector, and adapter cable harness 9813194 is for the 30-pin connector.
Disconnection of breakout box in reverse order.
Other information
- To remove the door panel, see Replacing the front door side panel .
- For further information about signals and other values, see Signal specification .