Checking diagnostic trouble codes (DTCs)

Fig 1: Identifying Ignition Switch ON Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Check the brake control module (BCM) connector. Check for contact resistance and oxidation
• Reinstall the components, reconnect the connectors etc.
• Ignition on
• Wait approximately 60 seconds
• Read off the status of the diagnostic trouble code (DTC).

  Replace the brake control module (BCM) if the status of the fault is permanent.

  Other information 

  • Access the control module connector.
  • To replace the brake control module (BCM), see Brake Control Module (BCM), replacing
  • See Contents
  Fig 3: Identifying VCT2000 Diagnostic Tool

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was the status of the diagnostic trouble code (DTC) permanent? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  Refer to Information