Installing Engine Block Components
NOTE:
Always use new seal washers and gaskets
Install
- thermostat housing (B52x4x)
- knock sensor (KS)
- flame trap
- the pipe screw for the water-heated crankcase ventilation.
If in doubt about the order of assembly see:
| B5xx4x Engine body, exposing |
| B6xx4x Engine body, exposing |
Install the flywheel and carrier plate. See Crankshaft seal rear, replacing .
For the correct tightening torques see:
| B5xx4x Tightening torque |
| B6xx4x Tightening torque |
The ignition coil alignment and the wiring routing follows the illustrations below.
B5xx4x
B6xx4x