Connecting The Breakout Box

Special tools: 

see 9511428

see 9511499

see 9511507

see 9813194

• Ignition off.
• Remove the door panel
• Disconnect the module connectors.
  NOTE: Unplug the 12-pin connector before the 30-pin connector.

Connect the adapter to the control module's connector. Connect breakout box see 9511428 and cable harness see 9511499 to the adapter.

Adapter cable harness see 9511507 is for the 12-pin connector, and adapter cable harness see 9813194 is for the 30-pin connector.

Disconnection of breakout box in reverse order.

Other information 

• To remove the door panel, see PANEL FRONT SIDE DOOR, REPLACING
• For further information about signals and other values, see SIGNAL SPECIFICATION .