Diagnostic Trouble Code (DTC) Information BCM-C110768
Condition
The steering angle sensor is initiated with a steering wheel movement of at least ±5° within a certain period after turning the ignition on.
Diagnostic trouble code BCM-110768 is generated if the steering angle is not initialized after 2 minutes of driving at a speed over 10 km/h (6.2 mph).
Initialization can also be performed after BCM-110768 has been stored before the ignition is turned off. The anti-spin warning light will then go off. BCM-110787 is also generated if initialization is not performed before the ignition is turned off.
Substitute Value
- AYC is blocked.
Possible Source
- The steering angle sensor has not been initialized after two minutes of driving over 10 km/h (6.2 mph).
This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.
Fault symptom[s]
- General warning light on.
- The anti-skid function is not operational.