Checking The Wiring And Component
- Ignition off.
Check the communication cable between the gear selector control module terminal #2 and the transmission control module (TCM) terminal #B31 (#B21). Check for a short-circuit to ground. See SHORT-CIRCUIT TO GROUND, PERMANENT FAULTS .
Replace the circuit board in the top panel if no fault is found in the cable.
Remedy as necessary.
Other information:
- To connect the breakout box, see CONNECTING THE BREAKOUT BOX
- To replace the circuit board in the top panel (standard), see PRINTED CIRCUIT BOARD GEAR SELECTOR ASSEMBLY/TOP PANEL, REPLACING
- To replace the circuit board in the top panel (geartronic), see PRINTED CIRCUIT BOARD GEAR SELECTOR ASSEMBLY/TOP PANEL GEARTRONIC, REPLACING
- For information about signals, see SIGNAL DESCRIPTION. TRANSMISSION CONTROL MODULE (TCM) .
Was a fault detected?
- YES
Refer to VERIFICATION
- NO
FAULT NOT FOUND: Troubleshooting has been completed.