GDL-Master And GDL-Slave: Check
WARNING: This page is about a different variant/trim than selected.
Check 1
Checking the power supply to Gas Discharge Lamp Module (GDL)
Conditions (unless otherwise specified): Ignition off.
- Connect the breakout box for the Central electronic module (CEM).
- Ignition on.
- Light switch in position 2.
Take readings between:
- Central electronic module (CEM) #E1 (#1) and ground.
HINT: This output powers both the left and right Gas Discharge Lamp Module (GDL).
The power supply to the Gas Discharge Lamp Module (GDL) must be 12 V and must not exceed 19 V.