Input Speed Sensor, Clutch Pedal Position Sensor - Removal & Installation
- Transmission
- Gearbox, removing
- Notes
- Preparatory work
- Removal
- Disconnect battery lead
- Remove engine compartment components
- Remove components from gearbox
- Remove gearbox mounting screws
- Remove coolant hose from passenger compartment heater
- Install lifting beam and lifting hook on engine lifting eyelet
- Remove air baffle and splash guard under engine
- Remove screw for cable duct
- Remove cross members from body
- Remove screws and nuts for engine pads, torque rod
- Measure position of tie rod in steering gear
- Expose steering shaft joint
- Remove front suspension components (both sides)
- Preparations when removing gearbox
- Preparations for lowering sub-frame
- Remove right-hand drive shaft
- Remove left-hand drive shaft
- Lower sub-frame
- Remove bevel gear
- Remove rear engine mounting
- Remove screws from torque converter
- Remove oil pipe from gearbox
- Lower engine and gearbox
- Install fixture on mobile jack and gearbox
- Remove all screws for gearbox and engine
- Remove gearbox
- Gearbox, installing
- Notes
- Installation
- Notes
- Install gearbox
- Install and tighten screws to gearbox
- Fit torque converter screws.
- Lift engine/gearbox
- Install rear engine mounting
- Install angle gear
- Install lower oil pipe to gearbox
- Install left-hand drive shaft to gearbox and wheel spindle
- Fit sub-frame to body
- Install right-hand drive shaft to gearbox, wheel spindle and link arm
- Tighten sub-frame screws (both sides)
- Fit screws for engine pads and torque rod bracket in gearbox
- Install steering wheel shaft joint
- Install crossmembers
- Install and tighten front suspension components
- Install cable conduit
- Remove lifting beam
- Install water hose
- Fit remaining screws to gearbox/starter motor
- Install gear selector cables and oil line
- Install service clips
- Install engine compartment components
- Finishing
- Gearbox input speed sensor, replacing
- Input speed sensor/output speed sensor, replacing
- Lubrication, transmission, specifications
- Oil level, transmission (AW55-50/51SN), checking
- Oil level, transmission (AW50-42), checking
- Pedal position sensor, clutch, replacing
- Gearbox, removing