Checking The Control Module

Fig 1: Identifying Control Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

• NOTE:

  Diagnostic trouble code (DTC) SUM-0262 may be stored if the Suspension Module (SUM) has previously been installed in another car.

Was the Suspension Module (SUM) previously installed in another car? 

• YES 

  Refer to Checking the control module 

• NO 

  Refer to Downloading software 

Fig 1: Identifying Ignition On Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Check that the P/N of the control module corresponds to the number in the replacement parts catalogue. If the P/N does not match the replacement parts catalogue, replace the control module. Download new software into the control module if the P/N matches the replacement parts catalogue. Select Pause. Save this page as a bookmark and cancel the fault-tracing. Then go to the software manager and download the correct software. Then resume the fault-tracing
NOTE:

After downloading the software, the Suspension Module (SUM) must be calibrated according to VIDA vehicle communication.

Fig 2: Identifying Control Module
Courtesy of VOLVO CARS OF NORTH AMERICA.
• Select an option: 
  1. Incorrect control module P/N
  2. New software downloaded.

• 1 

  OKAY:  Troubleshooting has been completed.

• 2 

  Refer to Reading off diagnostic trouble codes (DTCs)