Component Specifications
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Volvo V70, 2006 Volvo V70, 2005 Volvo V70, 2004 Volvo V70, and 2003 Volvo V70. However, it is still accessible from the selected car via links, so may be relevant.
The component specification gives the value of the component when the connector is disconnected. Where no value is given, it is not possible to measure a relevant value at the component.
The figure within the brackets indicates the terminal pin on the component to which the value refers.
| Designation | Type | Supply voltage | Value | Other |
| Active yaw control sensor | CAN node with integrated yaw rate sensor, lateral accelerometer and accelerometer (AWD only) | 12 V (#3-#5) |
Yaw rate sensor: °/s Lateral accelerometer: m/s2 Accelerometer: m/s2 |
The active yaw control sensor either contains two (2WD) or three (AWD) sensors and is connected to the brake control module with its own CAN lead. |
| Brake pressure sensor 1 & 2 | Pressure switch (Pressostat) | 5 V (#1-#3) |
Operating range 0-170 bar 21 bar when brake pedal is not depressed |
- |
| Pressure build-up valve | Electro magnetically controlled valve | 12 V | Pulse width modulated (PWM) signal | - |
| Wheel sensor | Hall sensor | 12 V | Tooth against sensor: I≈ 14mA U≈9V Cover against sensor: I≈7 mA U≈1V below Ubat |
- |
| Pedal pressure sensor | Two position switch | 12 V (#2-#5) NO (#1-#5) NC |
NO=Normally open NC=Normally closed |
- |
| Pedal position sensor | Slide potentiometer | 12 V | 0 mm: ≈ 0 V 38.5 mm: ≈ 95 % of Ubat |
- |