Vehicles With Fuel Pump Module Originally Located On Fuel Tank

Replace the rear cable harness with a new one.

On the new cable harness there is an integrated connection to the control module.

Fig 1: Identifying Fuel Pump & Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Plug in the connector by the sill and the fuel pump.

Place the cable harness in the seal ring's slot and in the brackets on the body.

Install the floor hatch and tighten with 6 Nm.

Check carefully that the seal is in place when the hatch is installed.

Fig 2: Identifying Control Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

The control module shall be placed in the spare wheel well's rear part on the right side, between the two markings and below the bead of sealing compound.

Remove the protective tape from the self-adhesive Velcro fastener and install the control module.

Plug in the cable's connector from the cable harness to the control module.