LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volvo >> 2007 >> C70 Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Keyless Vehicle Module (KVM) And Parking Assist Module (PAM) Diagnostic Trouble Codes >> KVM-E001: Control Module Communication. Faulty Communication (2006-2013) >> Faulty Communication (2006, 2007) >> Identifying A Control Module In The Can Network
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Identifying A Control Module In The Can Network

If the load on the CAN network is too high, this may be due to a control module transmitting faulty messages on the CAN network. This is called a disruptive control module. The fault may also be due to an intermittent short-circuit to supply voltage or ground in one of the CAN cables. This results in the control modules on the CAN network starting to send faulty messages. An intermittent short-circuit may occur without a diagnostic trouble code (DTC) being stored by any of the control modules.

NOTE:

It is not necessarily the control module(s) that stored the diagnostic trouble code (DTC) that is communicating faultily. Faulty messages can come from any control module in the same section of the CAN network. However, faulty communication in one network cannot affect the communication on the other network. In other words, faulty communication on LS-CAN cannot disrupt communication on HS-CAN and vice versa.

Check the communication/load on the CAN network by measuring the voltage between terminals #B8 (#8) and #B9 (#9). The average voltage must be approximately 0.5 V (0.4-0.6 V). If there is a fault in the communication, the voltage reading will be approximately 0.7 V or higher.

In order to identify which control module is communicating incorrectly, cut the power supply to one control module at a time. Check the voltage in the CAN cables again. The easiest way to cut the power supply is to remove the fuse(s) for the relevant control module. Continue until the voltage between the CAN cables drops to approximately 0.5 V.

HINT: When the suspected control module has been identified, connect and disconnect the supply voltage to the control module a number of times to verify that the fault appears and disappears. Switch off the ignition between each check. 

NOTE:

Do not cut the power to the central electronic module (CEM) unless it is the last control module left to check.

A control module that is communicating incorrectly must be replaced. Remedy as necessary.

NOTE:

Following a fault involving control modules that disrupt communication, other control modules may operate in Limp-Home mode (i. e. they work but with limited functionality) even after switching the ignition off and on a number of times. To remedy this, disconnect and reconnect the battery negative terminal to restore the control modules to normal function.

Remedy as necessary.

scientia non olet · About LEMON Manuals