April 5, 2026: LEMON Manuals is launched! Read the announcement.

Checking The Component And Wiring

Fig 1: Engine Start Verification

GLL101037

Courtesy of VOLVO CARS CORPORATION

Start the engine and run it to normal operating temperature.
Read off the fuel pump (FP) load (signal from the engine control module (ECM) to the fuel pump (FP) control module).

Check that the signal is approximately 50% (±10 %) with the engine idling at operating temperature.

Check the cable between engine control module (ECM) terminal #B20 (#C20) and fuel pump (FP) module terminal #1. Check for a short-circuit to ground. Check for an open-circuit.

Remedy as necessary.

Other information
- see CONNECTING THE BREAKOUT BOX
- see SIGNAL SPECIFICATION
- see FUEL PUMP DRIVER MODULE (2007)
- see CHECKING WIRING AND TERMINALS
Fig 2: Identifying 6-Bit Connector
Courtesy of VOLVO CARS CORPORATION

Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Fuel Pump (FP) Control Module
Courtesy of VOLVO CARS CORPORATION

Continue
Refer to VERIFICATION