Signal Too Low: Verification
NOTE:
After carrying out the repair, check that the fault has been remedied.
- Reinstall the connectors, components etc.
- Start the engine and run it to normal operating temperature.
Read off the fuel pump (FP) load.
Check that the engine starts and that the signal is approximately 35 % (±5 %) when the engine is idling at operating temperature.
Is the function correct?
- YES Troubleshooting has been completed.
- NO
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.