Faulty Configuration: Verification

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS CORPORATION

• Ignition on
• Wait for 20 seconds.
  NOTE:

  This first verification assumes that download of new software was required in the control module that generated the diagnostic trouble code. If download of new software was not required: read out diagnostic trouble codes and check if the code status is permanent or intermittent to learn how difficult it will be to find the fault.

  Read out all diagnostic trouble codes.

  Check that the diagnostic trouble code (DTC) for faulty communication is not stored again.

  Use the VCT2000 (or appropriate scan tool) to read diagnostic trouble codes (DTCs).

  Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS CORPORATION

Has the fault been remedied? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  Refer to TAKING READING ON CABLE IN THE CAN NETWORK (HS-CAN) 

HINT: Once a fault has been repaired, conduct a verification to check that the fault has been remedied. 

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS CORPORATION

• Reinstall the connectors, components etc.
• Ignition on
• Erase diagnostic trouble codes (DTCs) in all control modules
• Start the vehicle. Allow the vehicle to run for 10 minutes.

  Read off diagnostic trouble codes (DTCs).

  Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS CORPORATION

Is the diagnostic trouble code for configuration fault regenerated? 

• YES 

  Refer to INFORMATION 

• NO 

  OKAY:  Troubleshooting has been completed.