Diagnostic trouble code (DTC) information CEM-1A59
Condition
Diagnostic trouble codes (DTCs) are stored if the central electronic module (CEM) registers that communication with the audio module (AUM) is not operating.
NOTE:
In the event of CEM-1A5X diagnostic trouble codes (DTCs), the central electronic module (CEM) must not be replaced as the diagnostic trouble code (DTC) indicates a communication fault in the Control area network
Substitute Value
None.
Possible Source
- No power supply to the audio module (AUM)
- Open-circuit in the ground lead to the audio module (AUM)
- Contact resistance in the terminals
- Open-circuit in the wiring for the CAN low speed network to the audio module (AUM)
- - The audio module (AUM) is not intended for this car (for example a used control module with different software/hardware).
HINT: If several diagnostic trouble codes (DTCs) are stored in the central electronic module (CEM) for communication faults with other control modules in the low speed network, this indicates a common fault in the Control area network, see the wiring diagram.
Fault symptom[s]
- The rheostat function on the audio system is not working
- Cannot be controlled with the remote control
- Buttons on the steering wheel are not working.