Checking Signal Cable

Fig 1: Identifying Ignition Switch OFF Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Disconnect the connector from the central electronic module (CEM)
• Disconnect the immobilizer antenna unit.

  Check the signal cable between central electronic module (CEM) connector terminal #13D and immobilizer antenna unit terminal #3. Check for a short-circuit to supply voltage.

  Remedy as necessary.

  Other information: 

  • To access the central electronic module (CEM) connector, see Central electronic module (CEM), replacing
  • To access the immobilizer antenna unit/connector, see Antenna unit immobilizer, replacing
  • To connect the breakout box, see Connecting the breakout box
  • For information about signals, see Signal specification
  • See Checking wiring and terminals .
  Fig 2: Identifying Breakout Box

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 3: Identifying Voltmeter

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 4: Identifying Ignition Switch Bulb

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the signal cable OK? 

• YES 

  Refer to Replacing Central Electronic Module (CEM) 

• NO 

  Refer to Verification