Checking Fuses

Check that the fuse for the high-pressure washer is intact. Replace the fuse if necessary.

After changing fuse, erase trouble codes.

Activate ignition position II.

Try to activate the headlight washers with the lever.

HINT: The washer must be activated for more than 0.3 seconds for the high-pressure washer to be activated. The high-pressure washer is activated every fifth time that the washers are activated if not more than 10 minutes have passed since the last activation. Warning light for low washer fluid level may not be on. 

If the trouble code does not return and the high-pressure washer works, no further action is needed.

If the fuse fails again, or if the trouble code returns, continue troubleshooting.

Do you wish to continue with fault tracing? 

• YES 

  Refer to Checking the Component 

• NO 

  Refer to Verification