Checking the wiring

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Control Module Disconnected

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Disconnect central electronic module (CEM) connector C.

  The diagnostic trouble code (DTC) indicates that the communication between the alternator control module (ACM) and central electronic module (CEM) is not working. This may be due to a fault in the signal cable between the control modules or a damaged communication device in one or both of the control modules.

  Check the signal cable. Check for an open-circuit. Check for a short-circuit to ground.

  Take readings between central electronic module (CEM) terminal #C16 (#16) and alternator control module (ACM) terminal #B1.

  Remedy as necessary.

  Other information 

  • See Connecting the breakout box
  • See Signal specification
  • See Location of components
  • Replace the generator (GEN) for gasoline engines, see Generator (GEN), replacing
  • See Contents

Was a fault detected? 

• YES 

  Refer to Verification 

• NO 

  Refer to Replacing the control module