Checking the wiring
Check the signal cable between rear electronic module connector #B06 (#D6) and tilt sensor connector terminal #2. Check for an open-circuit.
Also check both connectors for contact resistance and oxidation.
If no fault was found, try a new sensor.
Other information
- For further information about signals and other values, see Signal specification
- To connect the breakout box, see Connecting the breakout box
- To access the rear electronic module, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing
- To access and replace the tilt sensor, see Tilt sensor alarm, replacing
- See Checking wiring and terminals. Permanent fault .
- Continue
Refer to Verification