Checking cable and component
- Disconnect connector C from the rear electronic module (REM).
HINT: The signal loop runs from rear electronic module (REM) terminal #48 (#C8) to the glass breakage loop in the right-hand rear window, to the glass breakage loop in the left-hand rear window and then to the ground terminal.
Check connector C for the rear electronic module (REM) and the terminals for the glass breakage loop. Check for contact resistance and oxidation.
Check the glass breakage loop and the intermediate cable between rear electronic module (REM) terminal #48 (#C8) and the ground terminal. Check for an open-circuit.
Remedy as necessary.
Other information
- See Connecting the breakout box
- See Signal specification
- Disconnecting the rear electronic module (REM): Rear electronic module (REM), replacing
- See Contents
- Continue
Refer to Verification