Replacing the component

Replace the back-up (reversing) lamp relay (position 2/80). Check the relay terminal, in particular relay guide 2/80 terminal #2, for an open-circuit.

Other information: 

• For further information about signals and other values, see Signal specification
• To access and replace the relay, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing
• When the relay is installed and not activated, the voltage at the relay guide must be 12 V
• See Checking wiring and terminals. Permanent fault .

Fig 1: Identifying Ohm Meter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Relays

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification