Checking components and wiring
Check that the position sensor for the xenon lamp is correctly installed.
Check the cable between the rear electrical module terminal #B8 (#A28) and position sensor terminal #4. Check the cable between rear electrical module terminal #B10 (#A30) and position sensor terminal #5. Check the cable between rear electrical module terminal #B6 (#A26) and position sensor terminal #1. Check for an open-circuit. Check for a short-circuit to ground.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For information about signals, see Signal specification
- To access or replace the position sensor for the Xenon lamp, see Replacing position sensors for Bi-Xenon lamps
- See Checking wiring and terminals .
- Continue
Refer to Verification