Checking components and wiring

Check the signal cable (+) between heated oxygen sensor (HO2S) terminal #4 and control module terminal #A61 (#B1). Check the signal cable (-) between heated oxygen sensor (HO2S) terminal #3 and control module terminal #A62 (#B2). Check for a short-circuit to supply voltage.

HINT: Use a test lamp with at least a 3 W bulb to determine whether the cable is short-circuited to supply voltage. 

Try a new heated oxygen sensor (HO2S) if the wiring is OK.

Remedy as necessary.

Other information: 

• To connect the breakout box / access the control module, see Connecting the breakout box
• To access or replace the heated oxygen sensor (HO2S), see Heated oxygen sensor (HO2S), replacing
• For information about signals, see ELECTRICAL SYSTEM
• See Contents .

Fig 1: Identifying Heated Oxygen Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Voltage Display

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Rear Heated Oxygen Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification