Checking cables: Notes
Check signal cable between control module #A47 (#A47) and camshaft position (CMP) sensor connector #2 for an open-circuit according to Open-circuit, permanent faults and a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults .
HINT: Use a test screwdriver with at least a 3W bulb to determine if the cable is short-circuited to supply voltage. Check the ground lead between control module #A65 (#A65) and camshaft position (CMP) sensor connector #3 for an open-circuit according to Open-circuit, permanent faults .
Other information
- Connecting the breakout box/accessing the control module, see Connecting the breakout box .
- For component location:
- For 5 cylinder turbocharged engines -2001, see Location of components
- For 5 cylinder turbocharged engines 2002, see Location of components, engine compartment
- For 5 cylinder turbocharged engines 2003-, see Location of components, engine compartment
- For B5254T4 2004-, see Location of components, engine compartment .
- For information about signals:
- For 5 cylinder turbocharged engines -2001, see Signal specification
- For 5 cylinder turbocharged engines 2002, see Signal specification
- For B5254T2 -2004, see Signal description
- For B5204T5, B5234T3, B5234T7 and B5244T3 -2004, see Signal specification (B5204T5, B5234T3, B5234T7 and B5244T3 -2004)
- For B5254T4 2004, see Signal specification (B5254T4 2004)
- For 5 cylinder turbocharged engines 2005-, see Signal specification .
- Continue
Refer to Verification