Checking cables: Notes
Check the signal cable between control module #A47 (#A47) and camshaft position (CMP) sensor connector #2 for a short-circuit to ground according to Short-circuit to ground, permanent faults . Check power cable between control module #A29 (#A29) and camshaft position (CMP) sensor connector #1 for an open-circuit according to Open-circuit, permanent faults .
HINT: With the ignition on and camshaft position (CMP) sensor connector disconnected the voltage between terminal #1 and ground terminal should be approximately 5 V.
Other information
- Connecting the breakout box/accessing the control module, see Connecting the breakout box .
- For component location:
- For 5 cylinder turbocharged engines -2001, see Location of components
- For 5 cylinder turbocharged engines 2002, see Location of components, engine compartment
- For 5 cylinder turbocharged engines 2003-, see Location of components, engine compartment
- For B5254T4 2004-, see Location of components, engine compartment .
- For information about signals:
- For 5 cylinder turbocharged engines -2001, see Signal specification
- For 5 cylinder turbocharged engines 2002, see Signal specification
- For B5254T2 -2004, see Signal description
- For B5204T5, B5234T3, B5234T7 and B5244T3 -2004, see Signal specification (B5204T5, B5234T3, B5234T7 and B5244T3 -2004)
- For B5254T4 2004, see Signal specification (B5254T4 2004)
- For 5 cylinder turbocharged engines 2005-, see Signal specification .
- Continue
Refer to Verification