Fault-Tracing Information

Use the following information and general checks during fault-tracing.

NOTE:

Check that the fuses are intact. or locations, see the instruction manual, cover for fuse box, fuse ratings or similar.

In the event of image problems: check that the Integrated Audio Module (IAM), Infotainment control module (ICM) and Rear seat entertainment module (RSE) have the same ground terminal. Also check that the contacts are not covered in verdigris.
Check, if possible, relevant functions in the vehicle using buttons/controls/test drives to determine the status of the fault.
NOTE:
If the vehicle does not show any of the given symptoms in the diagnostic trouble code information (DTC), this may mean that the fault is intermittent or that the control module is not detecting the fault at this moment.
Use the diagnostic trouble code's frozen values , status identifiers and counter to determine the operating conditions when the fault was detected, the fault's current status and any degree of intermittence of the fault.
Check and fault-trace according to the fault causes that are specified in the diagnostic trouble code (DTC) information .
Use VIDA Vehicle communication . Read off the parameters, activate components and functions, carry out quick tests and checking routines for the diagnostic trouble codes to identify the fault.
Check relevant components according to Component specifications .
Check relevant signals using wiring diagram , signal specification and breakout box .

Remedy as necessary.

Other information

Fig 1: Identifying VIDA (Volvo Scan Tool)

Courtesy of VOLVO CARS CORPORATION