Checking The Component And Wiring

Check the clutch pedal sensor resistance.

Check the signal cable between central electronic module (CEM) terminal #G21 (#21) and clutch pedal sensor connector terminal #3. Check for a short-circuit to ground.

Check the signal cable between central electronic module (CEM) terminal #G23 (#23) and clutch pedal sensor connector terminal #2. Check for a short-circuit to ground.

Check the signal cable between central electronic module (CEM) terminal #G12 (#12) and clutch pedal sensor connector terminal #1. Check for a short-circuit to ground.

Try replacing the clutch pedal sensor if no fault is found in the wiring.

Remedy as necessary.

Other information 

• see CONNECTING THE BREAKOUT BOX, CENTRAL ELECTRONIC MODULE (CEM)
• see SIGNAL DESCRIPTION CENTRAL ELECTRONIC MODULE (CEM)
• see CONTROL MODULE RELAY BOX PASSENGER COMPARTMENT
• see POSITION SENSOR CLUTCH PEDAL ENGINE COMPARTMENT
• see CHECKING WIRING AND TERMINALS

Fig 1: Identifying 2-Bit Connector

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS CORPORATION

• Continue 

  Refer to VERIFICATION