Checking The Connectors And Cables

Check the signal cable between engine control module (ECM) terminal #B26 (#C26) and accelerator pedal (AP) position sensor terminal #5 (wiring side). Check for an open-circuit. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.

Try a new accelerator pedal (AP) position sensor if no fault is found and the fault is permanent.

Remedy as necessary.

Other information 

• see CONNECTING THE BREAKOUT BOX
• see SIGNAL SPECIFICATION
• see ACCELERATOR PEDAL
• see CHECKING WIRING AND TERMINALS

Fig 2: Identifying 6-Bit Connector

Courtesy of VOLVO CARS CORPORATION

Fig 3: Identifying Ohm Meter

Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Accelerator Pedal (AP) Position Sensor

Courtesy of VOLVO CARS CORPORATION

Refer to VERIFICATION