Checking The Wiring

The signal for the lighting for the Volvo On Call buttons is pulse width modulated. To enable measuring and checking if there is a problem on the lead, pulse-width modulation (lighting intensity) needs to be set to a specific value.

• To check whether the fault is due to an open circuit, or short-circuit to ground, the value 10% must be set.
• To check if the signal has a short-circuit to voltage, the value 0% must be set.

Click on VCT2000 to set the desired value on the signal.

Open-circuit or short-circuit to ground 

• Check the voltage between terminal #C1:3 and #C1:6 to check the SOS button.

  Check the voltage between terminal #C1:4 and #C1:6 to check the SOS On Call button.

• If the value is lower than 3 V, the cable has a short-circuit to ground.
• If the measured value is greater than 8 V, this means that the cable is disconnected and that the circuit is open.
• Check the wiring and connectors

short-circuit to voltage 

• Check the voltage between terminal #C1:3 and #C1:6 to check the SOS button.

  Check the voltage between terminal #C1:4 and #C1:6 to check the SOS On Call button.

• If the value is greater than 8 V, the cable has a short-circuit to voltage.
• Check the wiring and connectors

Remedy as necessary.

Other information 

• see SIGNAL SPECIFICATION
• see LOCATION OF COMPONENTS
• see CONNECTING THE BREAKOUT BOX
• see CHECKING WIRING AND TERMINALS

Fig 1: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying SOS On Call Switch

Courtesy of VOLVO CARS CORPORATION

Was a fault detected? 

• YES 

  Refer to VERIFICATION 

• NO 

  Refer to CHECKING THE COMPONENT