Checking The Front Wheel Alignment

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS CORPORATION

• Adjust the front end before checking the steering wheel angle.
• Ignition on.
• Set the steering wheel to the straight forward position.
• Read off the steering wheel angle. With the steering wheel and the front wheels in the straight ahead position, the value for the steering wheel angle must be approximately 0°.
• Turn the steering wheel 90° to the right. Check that the value is correct.
• Turn the steering wheel 90° to the left. Check that the value is correct.

  If the steering wheel angle does not correspond to the position of the steering wheel, reset the steering wheel angle and calibrate the dynamic stability and traction control (DSTC) system.

  Other information 

  • see CONTACT REEL, ADJUSTING (2008, 2009) or CONTACT REEL, ADJUSTING (2010)
  Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS CORPORATION

Was the function OK? 

• YES 

  Refer to VERIFICATION 

• NO 

  Refer to CALIBRATION