Front Section

Fig 1: View Of Symbol Numbers

Courtesy of VOLVO CARS CORPORATION

Explanation of dimensions 

The dimensions in the table are listed as follows:

Symbol number 1 means that the measurement is taken from the center.

Symbol number 2 means that the measurement is taken from an edge.

Fig 2: Identifying Symbol Number 3 Measurement From The Bottom Of The Recess

Courtesy of VOLVO CARS CORPORATION

Symbol number 3 means that the measurement is taken from a cut mark. Measurements are taken from the bottom of the recess.

If only one measuring point symbol is displayed, the symbol applies to both measuring points. Otherwise the symbols are shown on each side of the dimension in the illustration.

Fig 3: Identifying Engine Compartment Measurements

Courtesy of VOLVO CARS CORPORATION