Identifying Components On The Lin Network That Belong To The Climate Control System (CCM)

HINT: When identifying damper motors, each damper motor must be run to its limit position. These operations can take up to 30 seconds. When identifying the damper motors it is important that a battery charger is connected. 

Fig 1: Checking Traffic Load On CAN Cables

Courtesy of VOLVO CARS CORPORATION

• Ignition off
• Reinstall the connectors, components etc.
  NOTE:

  Climate Control Module (CCM) and damper motors can be affected by the temperature. The vehicle should have normal room temperature when performing this service.

  Carry out identification as follows: 

  • Ignition on.
  • Click on the VCT2000 (Volvo Scan Tool) symbol. Wait until identification has been carried out.
  • Ignition off.
  Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS CORPORATION

• Continue 

  Refer to CALIBRATING THE CLIMATE CONTROL MODULE (CCM)