Checking The Component And Wiring

Check the terminals. Check for contact resistance. Check for loose connections. Check for oxidation.

Check the resistance of the overheat protection thermostat.

Check the cable between control module terminal #5 and the terminal for the overheat protection thermostat. Check for a short-circuit to ground.

Check the cable between control module terminal #6 and the terminal for the overheat protection thermostat. Check for a short-circuit to ground.

Remedy as necessary.

Other information 

• see COMPONENT SPECIFICATION
• see SIGNAL SPECIFICATION
• see FUEL FIRED BOOSTER HEATER WATER-IN-FUEL SENSOR
• see CONTENTS

Fig 3: Identifying 14-Pin Connector

Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Signal Cable

Courtesy of VOLVO CARS CORPORATION

Refer to VERIFICATION