Fault-Tracing Information
Before continuing with fault-tracing, the following must be checked:
- All tests for the relevant symptom must have been carried out.
- No component, connector or wiring faults etc. should have been detected.
Have all tests been carried out and no faults detected?
- YES
- NO
FAULT NOT FOUND: Troubleshooting has been completed.
Diagnostic trouble codes (DTCs) not stored earlier
Diagnostic trouble codes (DTCs) have probably been stored during repair work.
Check that all connectors and components have been correctly connected.
Diagnostic trouble codes (DTCs) stored earlier
Diagnostic trouble codes (DTCs) have probably been stored during incorrectly performed repair work
Check that fault-tracing has been carried out correctly according to the relevant fault-tracing instructions.
It is possible to interrupt or make a new attempt to erase diagnostic trouble codes (DTCs).
Do you want to repeat attempt?
- YES
- NO
Troubleshooting has been completed.