Description Of Frozen Values: General

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2013 Volvo C70, 2012 Volvo C70, 2011 Volvo C70, 2010 Volvo C70, and 2009 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Frozen values are parameter values that are stored when a diagnostic trouble code (DTC) is stored.

Not all the parameters described need to be implemented in the control module. This varies from system to system. Parameters can also vary depending on which type of transmission the car has.

Certain parameters can be displayed without a value or with implausible values. This can occur if the control module has not stored a value, when a base value has been stored instead or if the parameter is received via the CAN network when there is an error on the CAN network. For example, the transmission speed value may be excessive if the fault occurs for the transmission speed sensor.

Definition of an operating cycle

The definition of an operating cycle varies depending on the software version.

Alternative definitions

The ignition has been switched off, then switched on and finally switched off again
The ignition has been switched off, the engine started and finally the ignition switched off again
The ignition has been off, the engine started, the car driven at a speed above 30 km/h for more than 3 minutes and finally the ignition switched off again.