Signal Specification: General
All the values that are given are measured between the respective connection given in column 1 and #2 or #4 (ground).
Pins 3, 5 and 6 are not used.
| U= | DC voltage in volts (V) | Ubat = | Battery voltage in volts (V) |
| I = | Current in amperes (A) | Ulow = | Voltage approximately 0 V |
| F = | Frequency in Hertz (Hz) |
CONNECTOR C1
| ECU | Signal type | Ignition on | Miscellaneous |
| #C1:1 | Power supply | U=Ubat | Protected with a 10 A fuse |
| #C1:2 | Signal ground 1 | U=Ulow | - |
| #C1:3 | - | - | - |
| #C1:4 | Signal ground 2 | U=Ulow | - |
| #C1:5 | - | - | - |
| #C1:6 | - | - | - |
| #C1:7 | Control modules communication cable (CAN L) | U=1.0-2.5 V | - |
| #C1:8 | Control modules communication cable (CAN H) | U=2.5-4.0 V | - |
All the values that are given are measured between the respective connection given in column 1 and #2 (ground)
CONNECTOR C2
| ECU | Signal type | Ignition on | Miscellaneous |
| #C2:1 | Power supply | U=Ubat | - |
| #C2:2 | Signal ground | U=Ulow | - |