Checking Components And Wiring
- Ignition off.
Check the resistance of the clutch pedal sensor between terminals #2 and #4 (component side).
Check the clutch pedal and engine control module (ECM) connectors. Check for contact resistance and oxidation.
Check the signal cable between engine control module (ECM) terminal #B15 (#B25) and clutch pedal sensor terminal #2 (component side). Check for an open-circuit.
Check the signal ground cable between engine control module (ECM) terminal #B4 (#B14) and clutch pedal sensor terminal #4 (cable harness side). Check for an open-circuit.
Check the clutch pedal sensor installation. Search for damage and check the connections visually.
HINT: With the ignition on, the power supply to the clutch pedal sensor must be approximately 5 V (measured with the clutch pedal sensor disconnected), measured between terminals #2 and #4 (cable harness side).
Remedy as necessary.
Other information:
- see CONNECTING THE BREAKOUT BOX
- For 5 cylinder turbocharged engines -2004, see SIGNAL DESCRIPTION
- For 5 cylinder turbocharged engines 2005-, see SIGNAL SPECIFICATION .
- For 6 cylinder engines -2004, see SIGNAL SPECIFICATION
- For 6 cylinder engines 2005-, see SIGNAL SPECIFICATION .
- For resistance values: COMPONENT SPECIFICATIONS
- see PEDAL POSITION SENSOR CLUTCH, REPLACING
- see CHECKING WIRING AND TERMINALS
- Continue
Refer to VERIFICATION