Faulty Signal (2007): Verification: Verification

HINT: After carrying out the repair, check that the fault has been remedied.

CAUTION:

The pressure in the fuel injection system can reach approximately 650 kPa when this diagnostic trouble code (DTC) is stored. Use an adapted manometer.

Fig 1: Engine Start Verification

Courtesy of VOLVO CARS CORPORATION

Connect the manometer. See:FUEL PRESSURE GAUGE
Run the engine to operating temperature. Allow the engine to idle
Air conditioning (A/C) off.
Read off the relative fuel pressure.

The relative fuel pressure is calculated from the fuel pressure sensor and the atmospheric pressure sensor signal (= absolute pressure minus atmospheric pressure).

Check that the value on the manometer and the value displayed in VIDA are the same. If the values are different, this indicates incorrect function.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA (Volvo Scan Tool)
Courtesy of VOLVO CARS CORPORATION

Fig 3: Identifying Fuel Pressure Sensor
Courtesy of VOLVO CARS CORPORATION

Is the function OK?

YES
VERIFIED: Troubleshooting has been completed.
NO
Refer to INFORMATION