Vehicles With Fuel Pump Driver Module Located In The Right-Hand Rear Wheel Housing

Fig 1: Locating Pump Driver Module

Courtesy of VOLVO CARS CORPORATION

Fuel pump driver modules that are located under the inner fender on the right-hand side in the front part of the rear wheel housing are installed when replacing on the right-hand side under the rear bench

Fig 2: Identifying Ignition Switch In OFF Position

Courtesy of VOLVO CARS CORPORATION

Fig 3: Identifying Seat Rail Cover

Courtesy of VOLVO CARS CORPORATION

Remove:

the covers over the seat rails
screws for seat rails-body frame, 12 pcs

Lift out the seats.

Fig 4: Identifying Seat Rail Cover

Courtesy of VOLVO CARS CORPORATION

Fig 5: Folding The Carpet Back

Courtesy of VOLVO CARS CORPORATION

Fold the carpet back

Remove:

ventilation pipe
the insulation block
the insulation block

Fig 6: Identifying Right-Hand Cover Over The Fuel Pump.

Courtesy of VOLVO CARS CORPORATION

Remove the cover on the right-hand side over the fuel pump.

Fig 7: Locating Cable Harness Connectors

Courtesy of VOLVO CARS CORPORATION

Remove:

the cable harness connectors from the fuel pump
connection to the sill
the mounting on the floor for the cable harness

Fig 8: Cutting Off The Removed Cable Connectors

Courtesy of VOLVO CARS CORPORATION

Cut off the removed cable so that both connectors can be removed. This is done so that the cable can be removed from underneath.

Fig 9: Accessing Inner Fender

Courtesy of VOLVO CARS CORPORATION

Remove the right rear wheel.

Remove the rivet and plastic nuts for the inner fender.

Bend the fender liner out of the way.

Fig 10: Removing Module With Mounting

Courtesy of VOLVO CARS CORPORATION

Remove:

the module from the wheel housing assembly with the mounting
the cable harness with mountings