Checking The Cables From The FUSEBOX To The Central Electronic Module (CEM)

Remove windshield wiper relay 2/91 from the fusebox base.

Check the relay base terminals. Check for contact resistance and oxidation.

Check the cable between relay base 2/91 terminal #2 and central electronic module (CEM) terminal #13. Check for an open-circuit.

Install the relay.

Activate the relay.

Other information: 

• To connect the breakout box, see CONNECTING THE BREAKOUT BOX
• -2004: SIGNAL SPECIFICATION
• 2005-: SIGNAL SPECIFICATION
• see CHECKING WIRING AND TERMINALS .

Fig 1: Identifying Ohm Meter

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Connectors

Courtesy of VOLVO CARS CORPORATION

Was the function OK? 

• YES 

  Refer to VERIFICATION 

• NO 

  Refer to CHECKING THE CABLE FOR A SHORT-CIRCUIT TO GROUND