Vehicles With Fuel Pump Driver Module Originally Located In The Right-Hand Rear Wheel Housing

Fig 1: Plug, 974688

Courtesy of VOLVO CARS CORPORATION

Install two rubber plugs for the wheel housing.

Use: Plug, 974688

Fig 2: Accessing Inner Fender

Courtesy of VOLVO CARS CORPORATION

Install the inner fender with plastic nuts and rivets

Install wheel. See INSTALLING WHEELS

Fig 3: Control module, 30769225

Courtesy of VOLVO CARS CORPORATION

Place the module on the two embossings in the floor leaving a clearance for the seat frame of at least 5 mm.

Use: Control module, 30769225

Remove the protective tape for the Velcro attachments and install the control module.

Install the cable mounting for the connection at the sill, fuel pump and module as well as the mounting in the floor.

Use: Cable harness, 30724838

Fig 4: Identifying Right-Hand Cover Over The Fuel Pump.

Courtesy of VOLVO CARS CORPORATION

Check the cover seal for faults and check that the cables are in the cut-outs.

Check that the plugs are in the seal.

Install the cover and tighten to 6 Nm.

Fig 5: Cutting A Hole In The Insulation

Courtesy of VOLVO CARS CORPORATION

Mark and make a hole for the module in the insulation block.

Fig 6: Folding The Carpet Back

Courtesy of VOLVO CARS CORPORATION

Fold the carpet back

Install:

Fig 7: Identifying Covers Over Seat Rails

Courtesy of VOLVO CARS CORPORATION

Install