Removing The Control Module
- Wait 2 minutes after the ignition has been switched off. The main relay must be voltage free before the control module is removed from the car. If the engine cooling fan (FC) runs on after the ignition has been switched off, wait until it stops and then wait for a further 2 minutes
- Remove the cover over the control module box. Put the cover to one side.NOTE:
Do not touch the control module terminal pins with your fingers. Static electricity may damage components in the control module.
- Insert tool see 9995722 around the control module
- Move the upper section of the tool backwards as far as it will go. Pull up the tool
- Carefully pull up the control module.