Signal Specification
General
All the values given below are between the respective terminal in column 1 and terminal #A1 in column 2 (power ground) unless otherwise stated in parenthesis after the table entry.
NOTE:
It is important to check ground terminals before taking readings.
| U= | DC voltage in volts (V) | UAC = | AC voltage in volts (V) |
| Ubat = | Battery voltage (V) | f = | Frequency in Hertz (Hz) |
| Ulow = | Voltage approximately 0 V | t = | Time in seconds |
| PWM = | Pulse width modulated signal as a % |
Connector C1
SIGNAL TABLE
| Connection breakout box | Control module terminal | Signal type | Ignition on | Ignition off | Other |
|---|---|---|---|---|---|
| - | #C1-1 | 30-feed | U = Ubat | U = Ubat | |
| - | #C1-2 | ground, 30 supply | U=Ulow | U=Ulow |
Connector C2
SIGNAL TABLE
| Connection breakout box | Control module terminal | Signal type | Ignition on | Ignition off | Other |
| - | #C2-1 | Input, antenna | - | - |
Connector C3
SIGNAL TABLE
| Breakout box terminal | Control module terminal | Signal type | Ignition on | Ignition off | Other |
| - | #C3-1 | Output, optical | - | - | |
| - | #C3-2 | Input, optical | - | - |