Diagnostic Functions

GENERAL 

The control module has a built-in diagnostic system, Volvo Diagnostic, which continuously monitors internal functions as well as input and output signals.

DIAGNOSTIC TROUBLE CODES (DTCS) 

If the control module detect a fault, a diagnostic trouble code (DTC) is stored. A fault that was detected during the last operating cycle is defined as permanent. Other faults that are detected are defined as intermittent.

READING AND ERASING DIAGNOSTIC TROUBLE CODES (DTCS) 

Stored diagnostic trouble codes (DTCs) can be read off and erased using this function.

Diagnostic trouble codes (DTCs) can only be erased once all the diagnostic trouble codes (DTCs) have been read off at least once.

READING OFF THE CONTROL MODULE IDENTIFICATION 

VIDA identifies control modules by reading off a number of codes from the control module memory. The codes contain information about the control module: 

• unit number (control module including hardware and software)
• hardware P/N (control module without software)
• hardware serial number (control module without software)
• software P/N
• diagnostic software P/N

READING OFF EXTENDED DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION 

This function can be used to read parameters, status identifiers and counters stored at the same time as a diagnostic trouble code (DTC). These are called frozen values.

For more information, see: Vehicle communication information in Specifications, other.

READING OFF THE PARAMETER VALUES 

Using this function, the status or value of parameters can be read off. The status/value is presented digitally.

For more information, see: Vehicle communication information in Specifications, other.