Signal Specification, Subwoofer Module (Sub) [2008-2011]
SIGNAL SPECIFICATION
GENERAL
| U= | DC voltage in volts (V) | UAC = | AC voltage in volts (V) |
| Ubat = | Battery voltage (V) | f = | Frequency in Hertz (Hz) |
| Ulow = | Voltage approximately 0 V | t = | Time in seconds |
| PWM = | Pulse width modulated signal as a % |
CONNECTOR C1
SIGNAL TABLE, CONNECTOR C1
| Breakout box terminal | Control module terminal | Signal type | Ignition on | Other |
| #1 | 30-feed | Ubat | - | |
| #2 | Ground | Ulow | - |
CONNECTOR C2
SIGNAL TABLE, CONNECTOR C2
| Breakout box terminal | Control module terminal | Signal type | Ignition on | Other |
| #1 | MOST input signal | - | Optical input signal when the MOST network is activated | |
| #2 | MOST output signal | - | Optical output signal when the MOST network is activated |
CONNECTOR C3
SIGNAL TABLE, CONNECTOR C3
| Breakout box terminal | Control module terminal | Signal type | Ignition on | Other |
| #1 | Sub channel 1 (-) | - | - | |
| #2 | Sub channel 1 (-) | - | - | |
| #3 | - | - | - | |
| #4 | Sub channel 2 (-) | - | - | |
| #5 | Sub channel 2 (-) | - | - | |
| #6 | Sub channel 1 (+) | - | - | |
| #7 | Sub channel 1 (+) | - | - | |
| #8 | - | - | - | |
| #9 | Sub channel 2 (+) | - | - | |
| #10 | Sub channel 2 (+) | - | - |