Parking Assist Control Module: Testing and Inspection

Object Alarm Module Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair.

Parking Assist Control Module Replacement

If the parking assist control module needs to be replaced, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS)

2. Perform the SPS function Parking Assist Control Module Programming and follow the on-screen instructions.

3. Perform the SPS function Parking Assist Control Module Configuration & Setup and follow the on-screen instructions.

4. Clear DTCs after completing the programming procedure.

Parking Assist Control Module Reprogramming

Do not reprogram the parking assist control module, unless directed by a service procedure, or a service bulletin.

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS)

2. Perform the SPS function Parking Assist Control Module Programming and follow the on-screen instructions.

3. Clear DTCs after completing the programming procedure.